Instructions / Assembly

/1816
ASSEMBLY
MODEL # AXCBSAVN03-WH
b
c
a
1. Determine the location for the unit on the wall. The Top A should be
approximately 1 ¼” above the top of the Wall Mount Bar I when mounted.
2. Place the Wall Mount Bar I at the predetermined height. Use a level to ensure
that it is straight. The flat side of Wall Mount Bar I should face outward away
from the wall. Hole (c) should align with your studs. Carefully mark the position of
each hole using the tip of the Phillips Screw 5 .
3. Install two Wall Anchors 9 to positions (a), (b) using a Phillips screwdriver.
Anchors are self-tapping and do not need pre-drilled holes.
4. Use your drill to create 1 hole 0.15” diameter x 2” deep at position (c) .
STEP-13 - Positioning
STEP-14 - Attach Wall Mount Bar to Wall
1. Screw one Phillip Screw 5 through the
raised side of the Wall Mount Bar I at position (c).
2. Screw two Phillip Screws 5 through the
raised side of the Wall Mount Bar I at positions
(a), (b) where Wall Anchors 9 were placed.
3. Tighten all screws. Do not over tighten.
a
c
b
9
I
5
5
5
I
9