Installation Guide

/2119

ASSEMBLY

MODEL # AXCBCGAT-04

1. Determine the location for the unit on the wall. The Top A should be

approximately 1 ¼” above the top of the Wall Mount Bar H when mounted.

2. Place the Wall Mount Bar H at the predetermined height. Use a level to ensure

that it is straight. The flat side of Wall Mount Bar H should face outward away

from the wall. Hole (c) should align with your studs. Carefully mark the position of

each hole using the tip of the Phillips Screw 7 .

3. Install four Wall Anchors 10 to positions (a),(b),(d),(e) using a Phillips screwdriver.

Anchors are self-tapping and do not need pre-drilled holes.

4. Use your drill to create 1 hole 0.15” diameter x 2” deep at position (c) .

STEP-13 - Positioning

STEP-14 - Attach Wall Mount Bar to Wall

1. Screw one Phillip Screw 7 through the

raised side of the Wall Mount Bar H at position (c).

2. Screw four Phillip Screws 7 through the

raised side of the Wall Mount Bar H at positions

(a),(b),(d),(e) where Wall Anchors 10 were placed.

3. Tighten all screws. Do not over tighten.