Installation Guide
Table Of Contents
2. Use phillips screwdriver to tighten Screws. Do not over-tighten.
Screws Round Head 9 .
1. Attach Lid Support 4 into pre-drilled holes of Seat B and Divider C using Phillips
Step 7
NOTE: The screwdriver is not
included in the hardware pack.
1. Attach Seat B to 3 Hinges on Back F using Phillips Screws 7
( using pre-drilled holes underneath of Seat ).
2. Use phillips screwdriver to tighten Screws. Do not over-tighten.
Step 8
B
7
B
C
9
4
Assembly
Model # AXCAMH13-FB
16