Specifications

www.tksimplex.com
••• 3 •••
DANGER
: Do not handle pressurized hoses. Escaping oil under pressure can penetrate the skin, causing serious
injury. If oil is injected under the skin, see a doctor immediately.
DANGER
: Only use hydraulic cylinders in a coupled system. Never use a cylinder with unconnected couplers. If the
cylinder becomes severely overloaded, components can fail catastrophically causing severe personal injury or death.
3.0 TECHNICAL SPECIFICATIONS
PET 2041 / 2841
PET 2041A / 2841A
Voltage
115V
220V
Operating Pressure
10,000 PSI (700kg/cm
2
)
Electrical Power Source
15 Amps 115V Grounded 50/60 Hz
10 Amps 220V Grounded 50/60 Hz
Motor Rating
.5 Hp Permanent Magnet
10 Amps @ 10,000 psi (700kg/cm
2
)
.5 Hp Permanent Magnet
6 Amps @ 10,000 psi (700kg/cm
2
)
Flow Rate
400 cu. in./ min. @ 600 psi, 50 cu. in @ 10,000 psi (700kg/cm
2
)
Maximum Operating
Temperature
170�F - (65�C)
4.0
I
NITIAL INSTALLATION BEFORE OPERATING PUMP
4.1 Working Pressure
The pump’s maximum working pressure is 10,000 PSI (700kg/cm2). Make
sure that all hydraulic equipment such as rams, hoses, etc. used with this
pump are rated at 10,000 PSI (700kg/cm2) operating
pressure.
4.2 Install Vent Plug
Remove SHIPPING PLUG and install VENT PLUG into cover plate. Use
1.5 wraps of Tefl on tape (or suitable thread sealant) on all threads, leaving
the fi rst complete thread free of tape to ensure no foreign
matter enters the hydraulic circuit.
4.3 Adding Oil
Remove OIL FILLER CAP and add SIMPLEX Hydraulic Oil into reservoir. Oil level should
not exceed 1” from the reservoir cover.
4.4 Install Hydraulic Connections
Use only cylinders, tools, hoses and accessories rated at 10,000 PSI (700kg/cm2). Re-
move the shipping plugs from the ports to connect your coupling(s) or hose(s) to mani-
fold. Use 1.5 wraps of Tefl on tape (or suitable thread sealant) on all threads, leaving the
fi rst complete thread free of tape to ensure no foreign matter enters the hydraulic
circuit.
When making connections with quick disconnect couplings, make sure the couplings
are fully engaged. Threaded connections such as fi ttings, gauges, etc. must be se-
curely tightened and leak free.
WARNING
: Loose or improperly threaded fi ttings can be potentially dangerous if
pressurized, however, severe over tightening can cause premature thread failure. Fit-
tings need to be tightened secure & leak free. Never hold or stand directly in line with
any hydraulic connections while pressurizing. Never grab, touch or in any way come
in contact with a hydraulic pressure leak. Escaping oil can penetrate the skin and a
serious injury can result.
Filler Plug
Location
Vent Plug
Location
"A"
"B"
2 PORT FOR 1 TOOL USE
MULTI-PORT ADAPTER
8 PORTS FOR 4 TOOL USE
“B”
“A”