User`s manual
Setting the Time Zone for Atomic Clock Function
22
5 6
The Model EP800 can be set to one of the four United States time zones. Additionally, two
more options including no reception of WWVB signal are available with this model. By
default, the unit is shipped preset to Eastern Time.
Important Note: To set the Time Zone for Atomic Clock Function, you must start at Step 1
of "Setting the Display Hours". Continue from Step 3 of "Setting the Display Hours" to
Step 4 of "Setting the Time Zone".
1
2
3
4
5
6
Order Option
Eastern
Central
Mountain
Pacific
Other
No Reception
Notes
Default
Adjusts just "minute" and "second" by the WWVB radio signal.
You must set "date" and "time" to your local time first before
starting reception of the WWVB signal.
Disables atomic clock function and does not adjust time by the
WWVB radio signal.
4
In case of the example, push the
CHANGE button to set at "2", and
then push the SET button to finish
the setting. At that moment, the
display will change from flashing to
steady and the setting is now
completed.
5
Push the SET button once again.
Then the unit starts reception of the
WWVB radio signal.
Example: Change the time zone to "Central".
Signal Condition Indication
ON Good
FLASHING or OFF Not good enough
SET
SELECT
CHANGE
CLOCK
OPTION
Reception
Indication
Time
Zone
Please see "Radio Signal Reception"
on page 34 for more information on
the WWVB signal.
Setting the Display Hours
22
5
1
Push the DATE/TIME button for 5
seconds and position the " " under
the "CLOCK OPTION" mark.
A flashing number can be changed.
2
Push the CHANGE button to select
either "1" for AM/PM or "2" for 24
hour with the left-side number.
Set the "Display Hours"
.
SET
SELECT
CHANGE
CLOCK
OPTION
Display
Hours
Type of Hour
AM/PM (12 hour)
24 hour
For example,
PM
2:55
For example, 14:55
1
2
3
SET
SELECT
CHANGE
CLOCK
OPTION
"Display Hours" is the format that the hours appear on the clock face. The default is
"AM/PM".
Push the SET button to confirm the
setting. At that moment, the flashing
of display will change to the right-side
number. The unit is set to "1" for the
Eastern Time Zone. If you need to
change the time zone for atomic clock
function, go to Setting the Time Zone
for Atomic Clock Function.
If you don't need to change the time
zone setting shown on the display,
push the SET button two more times
to finish the setting. Then, the unit
starts reception of the WWVB radio
signal.