User`s manual

11
4
ENGLISH
Install the ribbon cassette so that the ribbon is between the print head and the ribbon
mask (see the figure on the left). Printing will not come out properly if the ribbon is
placed behind the ribbon mask (see the figure on the right).
65
Turn the knob of the ribbon cassette in
the direction of the arrow to tighten
the ribbon.
Knob
Print head
Ribbon mask
Ribbon
Print head
Ribbon mask
Ribbon
GNORWTCERROC
4
Set the antenna case down. Leave the
cover off while changing any settings in
the next step. When the settings are
complete, replace the cover.
2. QUICK SETUP
13
3
This setup should take approximately ten to fifteen minutes to completeif you use the default
settings. For this setup, take the clock to a comfortable position that has access to power.
Installing Ribbon Cassette
1
Hold the left and right sides of the cover
and lift up. Then, lift up the antenna
case.
2
Turn the knob of the new ribbon cassette
in the same direction as the arrow to
tighten the ribbon.
3
Place the ribbon cassette inside the
time recorder as shown in the figure.
Push the ribbon cassette until it snaps
into the clasps on both sides.
If it is
difficult to insert the ribbon cassette,
try it while turning the knob.
Knob
Clasp
Clasp
(located on both sides)
Knob
MAKE SURE THE POWER IS ON BEFORE INSTALLING.
Antenna Case