User`s manual

22
41
42
7. TROUBLESHOOTING
Error No. Causes and Actions
Contact SimplexGrinnell.
The front of the card must be completely filled
in before using the back of the card.
Make sure that another time card or another item
is not jamming in the time recorder. Try inserting
the time card again.
Make sure that another time card is not jamming
in the time recorder and the ribbon cassette is
correctly inserted in place.
After making sure of the above, close the cover.
If the error number continues to be displayed,
contact SimplexGrinnell.
Pay Period settings cannot be changed while cards
are stored in memory. An All Cards Reset must
be done before making changes to Print Format,
Pay Period type, or Pay Period start date.
1. Make sure cards are form 1950-4301 and made
by SimplexGrinnell.
2. Check to make sure the barcode area of the
card is not smudged or damaged.
Re-insert card after 1 minute has elapsed. Card
cannot be inserted twice in the same minute.
Ensure current date is within pay period dates.
May need to 'Reset Settings' if error continues
to be displayed.
Use the "Card Reset" function to reset the card.
Make sure if you can print by inserting the time
card with the same number.
Use the "Card reassign" mode to transfer the card
and have a new card take over for the old one.
CPU error
The remaining life of lithium battery for Return clock to SimplexGrinnell for service.
memory back-up is short.
Card inserted on wrong side.
The card is not pulled in properly.
Card sensor error
The printer motor or the sensor is not normal.
The card forwarding motor or the sensor does
not operate properly.
The print head motor or the sensor for the
printer head can not operate properly.
1. Remove and re-insert the ribbon.
2. Move clock to a dust free location.
3. Send to SimplexGrinnell for cleaning
and service.
Input the wrong settings.
Can't use the time card.
Calculation Error
Calculation Logic Error
Can't use the time cards because of memory
error.
When the card that you are using becomes full.
E-00
E-01
E-03
E-05
E-15
E-30
E-37
E-38
E-49
E-50
E-51
E-52
E-59
End
No. Error causes Action
* If the error number is still displayed after checking above points, contact SimplexGrinnell.
22
41
40
6
. INSTALLING BATTERY
(Optional)
Connector
Connector
Remove the lid of the battery
compartment on the back of the unit
by pushing up the center of the lid,
and then release it from the two
clasps.
Position the battery as shown in the
figure on the left .
* The connector cord should be on the
right side, as shown in the figure.
Connect the connector. Tuck away the
connector cord into the open space in
the compartment.
Insert the lid into the slot as shown on
the left. Keep pressing it down until
it hooks to the clasp.
* Make sure the cord is not caught
when closing the lid.
Lid
Clasp
Battery
Battery
1
2
3
4
Follow the steps below to install a battery (optional) so that the clock would be operational
during a power failure.
(P/N: 1410-5020)