User`s manual

22
35
36
Resetting Cards In Job Cost Mode
You can reset the card without removing the cover when the time recorder is used under
the following condition.
The Job Cost Mode and also the card "Reset" setting is YES.
Refer to "Job Cost Mode" in "Setting the Mode".
In order to reset the card, you must push the right-side button (Reset button) and then insert
the card.
After printing "RESET", the card shall be ejected.
Once you push the button, the unit starts beeping. Make sure to insert the card while it beeps.
Reset
button
Note: If the last punch was IN, you must insert the card twice.
A fully used card can also be reset by this operation, but without printing the word
"RESET".
22
35
34
Resetting Settings
To return all settings to their factory defaults.
Please note that all settings will be deleted and will revert to the factory defaults when
the reset switch is pushed. To make new settings, please refer to "Default and Advanced
Settings" (pages 7-8).
Stored cards are also deleted from memory.
If you want to just reset all cards, refer to "All cards reset" on page 38.
Reset switch
(inside the small
round hole)
Push the reset switch with a pointed
implement while pushing the
DATE/TIME and CHANGE button.
At that moment, the display will
change to AC " ".
And after a few seconds, the display
changes to date & time "1 12:00 a.m.".
CHANGE
DATE/ TIME
CHANGE
DATE/ TIME
CHANGE
DATE/ TIME
AM
1
2