User`s manual

EP10 Time Recorder User Guide
Page 9
Quick Easy Setup (Table Top Mount)
To setup your EP10, follow these next steps:
Step 1
Separate the back-plate from the
EP10 by removing the Philips
head screw. Retain the Philips
head screw for later.
Step 2
Plug the AC adapter into the
EP10 and then plug the wall
adapter into the AC outlet.
Step 3
Secure the back-plate to the EP10
with the Philips head screw being
careful not to pinch the AC cord.
Make sure the bottom of the timecard
shelf is over the edge of the back-
plate before securing the screw.
Place the EP10 on a solid flat surface.
You are ready to begin using the EP10.
Note: The time, date and other
settings are factory-set. See “Factory
Settings” to the right. If these settings
are acceptable you are ready to
begin, otherwise see Page 11
“Programming the EP10”.
Factory Settings
 Time=U.S. Eastern Time
 Daylight Savings=On
 Spring Daylight Savings=Second
Sunday in March
 Fall Daylight Savings=First
Sunday in November
 Displayed Time Format=AM/PM
hours & Minutes
 Printed Time Format=AM/PM
hours & Minutes
 Day of Week Language=English
 Confirmation Beep=Disabled