User`s manual

EP10 Time Recorder User Guide
Page 24
Function 14 – Confirmation Beep Disable/Enable
When prompted to select whether the confirmation beep will
sound or will be disabled, use the + button to scroll forward
or the - button to scroll backwards. With the desired setting
showing on the display, press the SET button. The „TruAlign
Calibration‟ function (15) will display next.
If enabled, a confirmation beep will sound after each imprint
on a timecard.
Setting Values
n = Confirmation beep disabled, this is the factory
setting
y = Confirmation beep is enabled
Example: Set the confirmation beep to enabled (y)
Step 1
Press the  or - button until the display
shows „y‟.
Step 2
Press the SET button when the setting is
correct. The setting will be accepted, go to
the „TruAlign Calibration‟ function.
Note: If you scroll past the setting you wish,
continue pressing the  or - button until
the desired setting displays, then press the
SET button.
14: y
14: n
Enable/Disable
Beep
Function #