Datasheet

Zeus 2.5-Inch ATA Solid State Drive 37
V 10 1 = Ultra DMA Mode 2 is selected
0 = Ultra DMA Mode 2 is not selected
V 9 1 = Ultra DMA Mode 1 is selected
0 = Ultra DMA Mode 1 is not selected
V 8 1 = Ultra DMA Mode 0 is selected
0 = Ultra DMA Mode 0 is not selected
F7:6Reserved
F 5 1 = Ultra DMA Mode 5 and below are supported
F 4 1 = Ultra DMA Mode 4 and below are supported
F 3 1 = Ultra DMA Mode 3 and below are supported
F 2 1 = Ultra DMA Mode 2 and below are supported
F 1 1 = Ultra DMA Mode 1 and below are supported
F 0 1 = Ultra DMA Mode 0 is supported
89 F Time required for Security Erase Unit completion
90 F Time required for Enhanced Security Erase completion
91 V Current Advanced Power Management value
92 V Master Password Revision Code
93 Hardware Reset Result. The contents of bits (12:0) of this word shall change only
during the execution of a hardware reset. See 7.16.7.41 for more information.
F 15 Shall be cleared to zero.
F 14 Shall be set to one.
V 13 1 = Device detected CBLID - above V
IH
0 = Device detected CBLID - below V
IL
12:8 Device 1 Hardware Reset Result. Device 0 shall clear these bits to
zero. Device 1 shall set these bits as follows:
F 12 Reserved
V 11 0 = Device 1 did not assert PDIAG-
1 = Device 1 asserted PDIAG-
V 10:9 These bits indicate how Device 1 determined the device number.
00 = Reserved
01 = A jumper was used.
10 = The CSEL signal was used.
11 = Some other method was used/method unknown
8 Shall be set to one.