Specifications
Section 2: PCB Installation and Startup
2-48 ◆ Section 2: PCB Installation and Startup Aspire S Hardware Manual
10. Perform a Cold Start.
a. Push in and hold the Load button.
b. Power the system back up.
c. Continue holding the Load button for approximately 3 seconds.
d. Release the Load button.
e. Allow the system to completely reload the software (approximately 2 minutes). The Status LED
(LD2) will be flashing on the CPU.
11. Reconnect to the system with PCPro and reload the database saved in Step 6 EXCEPT FOR PRO-
GRAMS 16-02, 11-07, 45-01, and all 47-xx. Downloading the complete database will cause prob-
lems with the IntraMail programing.
a. Click COMMUNICATIONS - UPLOAD.
b. Under the SELECT RANGE drop-down box, select SYSTEM CONFIGURATION and click
START.
c. Once that upload is complete, under the SELECT RANGE drop-down box, select SYSTEM
DATA. While holding down the CTRL key, scroll to each program which should not be down-
loaded (11-07, 45-01, and all the 47-xx programs) and click to deselect. Click START
d. Once that upload is complete, under the SELECT RANGE drop-down box, select TELE-
PHONE DATA. While holding down the CTRL key, scroll to Program 16-02 and click to dese-
lect. Click START
e. Once that upload is complete, under the SELECT RANGE drop-down box, select VE DATA
and click START.
A screen may appear indicating there is no data to upload. Simply click OK and continue
with the next upload.
f. Once that upload is complete, under the SELECT RANGE drop-down box, select TRUNK
DATA and click START.
g. Click CLOSE.
12. Click COMMUNICATIONS - DISCONNECT to exit system programming.
Exiting programming mode could take a minute or more while it saves the database.
13. Wait until the Status LEDs on the CPU have the following indications (approximately 2 minutes), then
power the system down.
LD1: Flashing Red, LD3: Flashing Red, LD4: Flashing Red, LD2: Steady Green.
14. Reinstall the PCBs removed in Step 8.
15. Turn the system power back on.
Refer to the Aspire IntraMail System Guide, Chapter 1 - Quick Setup (P/N 0893240) for
details on programming the IntraMail feature.