Specifications

Section 2: PCB Installation and Startup
Aspire S Hardware Manual Section 2: PCB Installation and Startup ◆ 2-43
2
Figure 2-17: TELEPHONE KEY LAYOUT
Setting Up Extension Circuit Types
Run Program 10-03 to set up extension circuit types as required. The system will automatically detect and
assign most circuit types when the device is connected. Refer to the Software Manual for programming
information.
1. Dial 10-03-01.
2. Select the slot, port or channel (with ESIU-S PCBs) to be programmed by pressing FLASH.
3. Set the terminal type or option as needed.
Refer to the Software Manual for this information.
If the system has DSS Consoles, Program 30-02 must be used to define DSS extension assignments.
As the system recognizes the extension devices automatically, when replacing the type of device connected,
the type must be undefined in Program 10-03 prior to connecting the new device. For example, if a port was
previously used for a keyset and a DSS Console is to be installed in that same port, it must first be undefined
in Program 10-03 before the console is connected.
Handsfree,
Handset,
Page and BGM
Volume Control
Alphanumeric
Soft Keys
Display
12 3 4 5 6
78 9101112
13 14 15 16 17 18
19 20 21 22 23 24
2
5
8
0
4
7
3
6
9
CALL 2
CALL 1
DND
HOLD
LND
DIAL
MIC
FLASH
SPK
VOL
CONF
MSG
Programmable
Function Keys
Abbreviated
Dialing
Dual Line
Appearance Keys
Last Number
Redial
Do Not Disturb
Microphone Cutoff
Speakerphone
Microphone
0893200 - 2
CLEAR
CHECK
SERVICE
RINGING
MENU 2
1
guide you through your
features. While your phone is
idle, the Soft Keys are normal
One Touch Keys.
Message Waiting
Lamp
MENU 1