Specifications

Section 2: PCB Installation and Startup
2-42 ◆ Section 2: PCB Installation and Startup Aspire S Hardware Manual
Initial Programming (Figure 2-17)
The system can be programmed using the following methods:
● Through a digital keyset
● Web Programming
Refer to the PCPro/WebPro Installation Manual, P/N 0893201, for complete installation details.
Refer to the Aspire Software Manual (P/N 083200) for complete details on programming.
Entering the Programming Mode
Enter the system programming mode at extension 301:
1. Press CALL1. (You hear dial tone).
2. Dial # * # *.
3. Dial the system password.
4. Press HOLD.
Port Defaults
With the default settings, the ports are assigned as follows:
Making Test Calls
In the initial configuration:
● All Programmable Function keys are line keys (e.g., key 1 is line 1).
● All trunks are loop start DTMF.
Password Level
12345678 2 (IN)
0000 3 (SA)
9999 4 (SB)
Station Ports: 1-26 (extensions 301-499 and 5000-5312)
Virtual Station Ports: 1-24 (extensions not assigned)
Trunk Ports: 1-8