Specifications

Section 2: PCB Installation and Startup
Aspire S Hardware Manual Section 2: PCB Installation and Startup ◆ 2-33
2
Installing an IntraMail Compact Flash Card:
The system must be powered down prior to installing the IntraMail card.
1. If not already installed, install the DSPDB daughter board. Included with the DSPDB are four spac-
ers. Install one spacer in each corner of the daughter board. Make sure to attach the spacers from
the back of the daughter board so when installed, the compact flash slot is facing up.
2. Position the daughter board over the CN4 connector on the CPU. Push the board into the connector
on the CPU. Gently push the corners of the daughter board down so the spacers lock into the CPU.
To remove the daughter board, use pliers to squeeze the top of the spacers together, then gently
pull the daughter board off.
3. Insert the IntraMail CompactFlash card into the slot in the DSPDB.
Figure 2-14: INTRAMAIL INSTALLATION
Refer to the Aspire IntraMail System Guide, P/N 0893240, for programming details.
0893100-165
IntraMail
CN1
CN4
CPU
Spacers