Specifications

Section 6: LAN Connection

Aspire S Hardware Manual Section 6: LAN Connection ◆ 6-5

Installing a LAN Device or VoIP Telephone

Actual installation will vary depending on each customer’s installed Aspire S and networking hardware.

1. Plug a cable with an RJ-45 modular jack into the system’s VoIP PCB.

2. Connect the RJ-45 modular connector on the opposite end of the cable to the IP telephone or PC’s

network interface card (NIC).

When connecting an IP telephone, a connection can then be made to a network PC using the PC

connector on the back of the phone.

3. If local power is to be provided to the IP telephones, connect the AC adapter to the phone.

When using the IPhone (P/N 0890065), set the SW2 dip switch on the bottom of the phone to the

appropriate setting shown below:

4. Plug the AC adapter into an outlet.

Feeding Method Power Source Setting of SW2

Local Feeding AC Adapter 1

(48 volts to phone)

Center Feeding NEC Power Patch Panel

(12 port NEC SN1604 PWRMS -

24-port NEC BlueFire 200/24)

Center Feeding Cisco Catalyst Power Patch Panel 2

(data pairs)

Cisco Catalyst PRW Series