System information

262
AS/400 IBM Network Station: Techniques for Deployment in a WAN
A.3 Support for NC Navigator with Java Virtual Machine
The files required to start the Network Station and run the NC Navigator
Browser and the Java Virtual Machine from the Flash card is found in this
section.
There is no change to the
flash.nsm and peer.nsm files because all of the
configuration for NC Navigator is done on the server using IBM Network
Station Manager program. The only difference is the files which are required
on the Flash card. This setup requires at least 20 megabytes of storage
space on the Flash card, if the uncompressed kernels for all systems are
used.
If the compressed kernel and mods files for only the Series 100/300 or Series
1000 is required, the size drops to less than 16 Mbytes.
For more information about configuring and using NC Navigator for the
Network Station, refer to the manual
IBM Network Station Manager
Installation and Use,
SC41-0664.
Disk caching should
not be used when running NC Navigator with Flash card
support. The system is shipped with disk caching disabled, and this setting
should
not be changed because of the limitation of the Flash card. Refer to
Chapter 3, “Using Flash Cards with the Network Station” on page 63 for more
information.
The byte count for the files listed here, with support for the Series 100,300
and 1000 using uncompressed kernels, is 21,333,568 bytes.
The following is a list of the files required on the Flash card:
/local/
boot.nsl
kernel [kernel.Z, kernel.63a, kernel.63Z]
/local/java/
classes.zip
javacpa0.gif
javacpat.gif
nwshacl.zip
nwspackg.zip