System information

Using a Network Station to Access Mail
235
3. Click
Next
at the bottom of the display. The Network Setting display
appears as shown in Figure 141.
Figure 141. Network Settings - System Defaults Display
4. Enter the
HTTP Proxy address
and
Port number
.
5. Click
Finish
to end and save configuration.
8.3.1.2 Loading NC Navigator from Network Station
Use the following steps to load the NC Navigator on the IBM Network Station:
1. Logon to the Network Station.
2. After the login is complete, clicks
NC Navigator
on the menu bar.
After a few moments, the NC Navigator display is shown. An example of
this display is shown in Figure 142 on page 236.