System information

Using a Network Station to Access Mail
231
8.2.1.2 Starting RMI and eSuite Registry Server from AS/400 System
The RMI and eSuite Registry servers run on the AS/400 system and must be
started before starting the eSuite Workplace on your Network Station.
To start the RMI and eSuite registry servers, run the following command at an
AS/400 command prompt:
QESUITE/STRESRSVR
A message indicating the eSuite registry server has started is sent to the
QSYSOPR message queue. The message is shown in Figure 138.
Figure 138. QSYSOPR Message Queue Showing Start of eSuite Server
8.2.2 eSuite Mail Configuration on Network Station
This section describes how to setup and configure eSuite mail on the Network
Station to access POP3 Server on the AS/400 system.
1. To access eSuite mail, click
My mail
under
Mailbox in the eSuite
Workplace. The following display is shown (see Figure 139 on page 232).
If the user or group does not receive the main Lotus eSuite Workspace
desktop, after logging on to the Network Station, ensure that both the RMI
and eSuite servers are active on the AS/400. These jobs, QESRRMI and
QESRSVR, run in the QSYSWRK subsystem. Details on starting these
servers are included in the following section.
Note
Display Messages
System:
Queue . . . . . : QSYSOPR Program . . . . : *DSPMSG
Library . . . : QSYS Library . . . :
Severity . . . : 90 Delivery . . . : *HOLD
Type reply (if required), press Enter.
Adapter has inserted or left the ring on line TRNLINE.
Adapter has inserted or left the ring on line TRNLINE.
Adapter has inserted or left the ring on line TRNLINE.
eSuite registry server (014486/QESUITE/QESRSVR) starting.