System information

206
AS/400 IBM Network Station: Techniques for Deployment in a WAN
adapter of the system. In this case, this parameter has the value of 10.1.1.2.
A display device also exists for each of the attached Network Stations.
Figure 116 and Figure 117 show the information that can be viewed within the
Network Station’s Setup Utility. However, these displays are what you see
before the Network Stations are powered up in this scenario. The Setup Utility
can be accessed by powering off the Network Station and then powering it
back on. When the message, NS0500
Search for Host System ,is shown on
the display, press
ECS
.
Figure 116. Set Network Parameters Display (Before Bootup)
If your system currently does not have DHCP configured and running, refer
to Section 5.7, “Twinax IBM Network Station with Local DHCP Server
Scenario” on page 154 for instructions on how to set up the DHCP server.
Note
IBM Network Station
Set Network Parameters
IP Addressed from ................................ NVRAM
Boot Host IP Address:
First Host ..................................... 10.1.1.193
Second Host .................................... 0.0.0.0
Third Host ..................................... 0.0.0.0
Configuration Host IP Address:
First Host ..................................... 0.0.0.0.
Second Host .................................... 0.0.0.0
Figure 117 on page 207 shows the NVRAM settings. However, when the
Network Station is ready to boot, the F3 display must show the
Network
setting.
Note