System information

194
AS/400 IBM Network Station: Techniques for Deployment in a WAN
5.9.6 Task Summary
The following tasks are required to complete this scenario:
1. Configure the DHCP server As1 for returning information to the twinax
subnet that contains the IP address of a base and configuration server.
2. Ensure that the proper TCP/IP servers are started on the As2 system.
3. Configure and start the twinax IBM Network Station.
4. Test connectivity.
5.9.7 Configuring the DHCP Server on As1
We will configure a boot server for the IBM Network Station. This is different
from the DHCP server to which the Network Station is connected.
To configure the boot server, complete the following steps:
1. Use the AS/400 Operations Navigator on System As1 to open the DHCP
server configuration window. Right click on the Twinax Subnet that was
previously configured. Highlight
Properties
. The resulting display is
shown in Figure 102 on page 195.
It is assumed, in this scenario, that the DHCP server on the As1 system
already functions correctly and supports the attached twinax Network
Stations. If this is not the case, refer to Section 5.7, “Twinax IBM Network
Station with Local DHCP Server Scenario” on page 154. This section
outlines the necessary steps needed to configure the DHCP server for
twinax support.
Note
The Operations Navigator displays, shown in this section, were captured
from a PC running IBM AS/400 Client Access for Windows 95/NT Version 3
Release 2 Modification Level 0.
Note