System information

178
AS/400 IBM Network Station: Techniques for Deployment in a WAN
2. From a command line, enter CHGDHCPA MODE(*RELAY),and press
Enter
. This
changes the mode of the DHCP server to be a BOOTP/DHCP Relay
Agent.
3. From Operations Navigator, select
As1
—>
Network
—>
Servers
—>
TCP/IP
and right-click on
BOOTP/DHCP relay agent
as shown in
Figure 86. Click on
Configuration
to select it.
Figure 86. AS/400 Operations Navigator - Configuring BOOTP/DHCP Relay Agent
4. The BOOTP/DHCP Relay Agent properties window appears. Click the
Start when TCP/IP is started
check box to ensure that it is checked.
5. Click
Add
.
6. Use the pull-down option on the
Interface address field to select the
TCP/IP interface from which the BOOTP/DHCP Relay Agent accepts
DHCP packets. This is the workstation controller interface was
automatically created. Select the
10.1.1.193
interface.
7. Specify the IP address of the DHCP server to which the DHCP messages
from the clients (IBM Network Stations) are sent. In this scenario the
address that is used is
10.1.1.50
.
Note
: You can specify the system name in this option if your DNS server
resolves IP addresses or if the host table on the system has been
configured correctly.
8. Leave the
Maximum hops set to the default of
4
.
9. Leave the
Packet transmission delay at
0
(zero).