System information

176
AS/400 IBM Network Station: Techniques for Deployment in a WAN
Figure 83. Automatically Created QTDL Descriptors
A TCP/IP interface has also been automatically created. You can view this by
typing
CFGTCP on a command line and then selecting option
1
. The resulting
display is shown in Figure 84.
Figure 84. CFGTCP Option 1 Display Showing the TDLC Interface
After the necessary configuration is created, you can power off the IBM
Network Station and proceed to the next step.
Work with Configuration Status AS1
09/21/98 12:10:15
Position to . . . . . Starting characters
Type options, press Enter.
1=Vary on 2=Vary off 5=Work with job 8=Work with description
9=Display mode status 13=Work with APPN status...
Opt Description Status -------------Job--------------
QTDL826400 ACTIVE
QTDL8NET ACTIVE
QTDL8TCP ACTIVE QTCPIP QTCP 006736
Work with TCP/IP Interfaces
System: AS1
Type options, press Enter.
1=Add 2=Change 4=Remove 5=Display 9=Start 10=End
Internet Subnet Line Line
Opt Address Mask Description Type
10.1.1.2 255.255.255.0 TRLAN2 *TRLAN
10.1.1.193 255.255.255.192 QTDL826400 *TDLC
127.0.0.1 255.0.0.0 *LOOPBACK *NONE
If only the message NS0500 is logged on the Network Station and there are
no messages logged in QSYSOPR message queue, check the System
Value QAUTOCFG. If this value is set to
OFF, change it to
ON
before
connecting and configuring twinax IBM Network Stations to your AS/400
system.
Note