System information

169
Figure 78 shows the interface descriptor when it is first created by the
system. Notice the LCLIFC parameter defaults to *NONE.
Figure 78. TCP/IP Interface for the Local Workstation Controller
For the twinax IBM Network Station to see and be seen across the network,
the LAN interface must be
manually added in the LCLIFC parameter of the
TCP/IP TDLC interface.
To add the LAN interface, complete the following steps:
1. From an AS/400 session, enter
CFGTCP on any command line.
2. Select option
1
(Work with interfaces).
3. To end the TDLC interface, select option
10
.
4. Select option
2
to change the interface. In this scenario, the 10.1.1.193
interface is ended.
5. Input the value
10.1.1.2
into the
Associated local interface parameter and
press
Enter
. A display of the Interface description is shown in Figure 79 on
page 170.
6. Start the TDLC interface.
7. At this point, the twinax IBM Network Stations should show the initial login
display. Because of the change we made to the IP interface, reboot the
Network Stations.
Display TCP/IP Interface
System: AS1
Internet address . . . . . . . . . . . . . . . : 10.1.1.193
Subnet mask . . . . . . . . . . . . . . . . . : 255.255.255.192
Line description . . . . . . . . . . . . . . . : QTDL825900
Line type . . . . . . . . . . . . . . . . . . : *TDLC
Associated local interface. . . . . . . : *NONE
Interface status . . . . . . . . . . . . . . . : Active
Type of service . . . . . . . . . . . . . . . : *NORMAL
Maximum transmission unit . . . . . . . . . . : *LIND
Automatic start . . . . . . . . . . . . . . . : *YES