System information

164
AS/400 IBM Network Station: Techniques for Deployment in a WAN
17.Click
OK
.
18.Close the DHCP configuration window. If the DHCP server is running, you
are asked to save the changes you made. Click
YES
. If the DHCP server is
not running, the configuration GUI closes and returns you back to the
TCP/IP server display.
19.Start the DHCP server by right clicking on
DHCP
and select
Start
. If the
DHCP server starts successfully, the
status is updated as shown in Figure
74 on page 164.
Figure 74. AS/400 Operations Navigator - TCP/IP Server Status
5.7.9 Configuring and Starting the IBM Network Station
It is assumed that you have cabled the twinax IBM Network Stations correctly.
If you are replacing non-programmable terminals (NPTs) with the twinax IBM
Network Station, notice the twinax address and port that the old NPT was
If the DHCP Server fails to start, ensure that the BOOTP server is stopped.
You cannot run both the BOOTP and DHCP server on the system at the
same time.
Note