System information

Twinax Attachment of Network Stations
157
Figure 65. Applying Subnet Mask to Carve a Contiguous Range for Twinax Subnet
5.7.8 Configuring the DHCP Server As1 for Twinax Support
Operations Navigator DHCP configuration is twinax aware. If you have
planned the IP addresses to use on the twinax subnet, the configuration of
the DHCP server is straightforward.
On the DHCP server (As1 system), which has the IBM Network Stations
attached using twinax to workstation controller CTL01, follow these steps to
configure DHCP support for TCP/IP over twinax:
1. Start the AS/400 Operations Navigator.
2. Click
As1
to select the system. The display shown in Figure 66 on page
158 appears.
0 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128 136 144 152 160 168 176 184 192 200 208 216 224 232 240 248 255
4 12 20 28 36 44 52 60 68 76 84 92 100 108 116 124 132 140 148 156 164 172 180 188 196 204 212 220 228 236 244 252
.128
.192
.224
.240
.248
.0
24
25
26
27
28
29
Mapping Subnet Mask Settings to Host Address Ranges
Number of
contiguous
bits:
Mask
Settings:
Twinax Subnet range
The Operations Navigator displays shown in this section were captured from
a PC running IBM AS/400 Client Access for Windows 95/NT Version 3
Release 2 Modification Level 0.
Note