System information

Twinax Attachment of Network Stations
151
Figure 59. TCP/IP Interface Status Display
If you return to the Network Station, the boot process should be
continuing. The TDLC component, on the AS/400 system, sends an
initiation link to the IBM Network Station. This initiation link contains:
• The assigned TCP/IP address (10.1.1.194 in this scenario) for the
Network Station.
• The IP address (10.1.1.193 in this scenario) for the Twinax interface.
• The configuration directory (in this scenario
/QIBM/ProdData/NetworkStation/configs/ ).
The IBM Network Station updated its own NVRAM settings with the Boot
Host IP Address (within the F3 display of the Setup Utility). Within the F5
display of the Setup Utility, the configuration directory is updated.
On the AS/400 system, the QTDLC line, controller and device are now
ACTIVE as shown in Figure 60.
Figure 60. Configuration Status of QTDL Descriptors
Work with TCP/IP Interfaces
System: AS1
Type options, press Enter.
1=Add 2=Change 4=Remove 5=Display 9=Start 10=End
Internet Subnet Interface
Opt Address Mask Status
10.1.1.2 255.255.255.0 Active
10.1.1.193 255.255.255.192 Active
127.0.0.1 255.0.0.0 Active
Work with Configuration Status AS1
10/02/98 10:52:01
Position to . . . . . Starting characters
Type options, press Enter.
1=Vary on 2=Vary off 5=Work with job 8=Work with description
9=Display mode status 13=Work with APPN status...
Opt Description Status -------------Job--------------
QTDL827500 ACTIVE
QTDL8NET ACTIVE
QTDL8TCP ACTIVE QTCPIP QTCP 009024