System information

Twinax Attachment of Network Stations
149
The display device created underneath the workstation controller (CTL01 in
this case) is shown in Figure 56. This figure also shows the console, DSP01,
for the AS/400 system.
Figure 56. Configuration Status Display of Automatically Created Display Device
The next step is to create an IP interface for the automatically created TDLC
line. In Figure 55 on page 148, this line is QTDL827400. Complete the
following steps:
1. Type
ADDTCPIFC on any command line and press
F4
.
2. Enter values for the
Internet address (INTNETADR), Line description
(LIND),
Subnet mask (SUBNETMASK) and Associated local interface
(LCLIFC
) parameters. The LCLIFC parameter is necessary in this
scenario, to allow the IBM Network Stations to communicate beyond the
workstation controller. The LCLIFC
parameter associates the twinaxial
interface with the LAN (token ring) interface. The values used in this
scenario are shown in Figure 57 on page 150.
Work with Configuration Status AS1
10/02/98 10:06:17
Position to . . . . . Starting characters
Type options, press Enter.
1=Vary on 2=Vary off 5=Work with job 8=Work with description
9=Display mode status 13=Work with APPN status...
Opt Description Status -------------Job--------------
CTL01 ACTIVE
DSP01 SIGNON DISPLAY
DSP02 ACTIVE