System information

148
AS/400 IBM Network Station: Techniques for Deployment in a WAN
Figure 54. Display of QSYSOPR Message Queue on AS/400 System
The QHST log, on the AS/400 system, has additional messages logged. For a
sample of these messages, refer to Figure 38 on page 133.
The system automatically creates a QTDLC line, controller and device as
shown in Figure 55.
Figure 55. Configuration Status Display of Automatically Created QTDL Descriptors
Display Messages
System: AS1
Queue . . . . . : QSYSOPR Program . . . . : *DSPMSG
Library . . . : QSYS Library . . . :
Severity . . . : 90 Delivery . . . : *HOLD
Type reply (if required), press Enter.
Automatic configuration created device description DSP02.
Line QTDL827500 varied on successfully.
DSP02 cannot connect. TCP/IP interface not added for line QTDL827500.
Controller QTDL8NET contacted on line QTDL827500.
If the message NS0500 is logged on the Network Station and there are no
messages logged in QSYSOPR message queue, check the System Value
QAUTOCFG using the AS/400 command
DSPSYSVAL QAUTOCFG. If this value is
set to
OFF , change it to
ON
before connecting and configuring twinax IBM
Network Stations to your AS/400 system.
Note
Work with Configuration Status AS1
10/02/98 10:04:53
Position to . . . . . Starting characters
Type options, press Enter.
1=Vary on 2=Vary off 5=Work with job 8=Work with description
9=Display mode status 13=Work with APPN status...
Opt Description Status -------------Job--------------
QTDL827500 ACTIVE
QTDL8NET VARIED ON
QTDL8TCP VARIED OFF