System information

Twinax Attachment of Network Stations
147
address of 10.1.1.193 is designated for the workstation controller (interface
address).
Figure 53 provides a visual representation of the address space that is
allocated to the twinax subnet.
Figure 53. Applying Subnet Mask to Carve a Contiguous Range for Twinax Subnet
5.6.8 Configuring and Starting the IBM Network Station
For this scenario, the same steps as described in Section 5.4.8, “Configuring
and Starting the IBM Network Station” on page 130
should be followed.
5.6.9 Configuring an AS/400 IP Interface
After the necessary changes are made to the Network Station configuration
using the IBM Network Station Setup Utility, reboot the Network Station. The
boot up process logs messages
NS0010 through NS0500 Search for Host.
When the NS0500 message is logged, review the messages logged in the
QSYSOPR message queue on the AS/400 system. Messages, similar to
those in Figure 54 on page 148, are logged.
0 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128 136 144 152 160 168 176 184 192 200 208 216 224 232 240 248 255
4 12 20 28 36 44 52 60 68 76 84 92 100 108 116 124 132 140 148 156 164 172 180 188 196 204 212 220 228 236 244 252
.128
.192
.224
.240
.248
.0
24
25
26
27
28
29
Mapping Subnet Mask Settings to Host Address Ranges
Number of
contiguous
bits:
Mask
Settings:
Twinax Subnet range