System information

Using Flash Cards with the Network Station
103
If prompted for an administrator password, enter it now (this is the
password an administrator can set using the IBM Network Station
Manager program).
6. Press
PF3
(
Set Network Parameters).
7. The Network parameters should default to NVRAM after the reset. To
change the
IP Addressed from field from Network to
NVRAM
, use the right
arrow key.
8. Enter the
Network Station IP address , in this scenario the IP address of
the Network Station is
10.1.1.11
.
9. Enter
The First Boot Host IP address of
10.1.1.10
. This is the Flash card
enabled IBM Network Station.
10.Enter
The First Configuration Host IP address of
10.1.1.2
. This is the
serving AS/400.
11.Enter the correct IP address information for the fields;
Gateway IP
Address, Subnet Mask
. The Broadcast IP address should default to the
correct setting.
12.Press
Enter
.
13.Press
PF4
(
Set Boot Parameters).
14.Type
kernel.Z
in the Boot File field.
15.In the
NFS Boot Directory field enter
/peerboot/.
This forces the Network
Station to load the kernel from the Flash card.
16.Leave the TFTP
Boot Directory blank.
17.In the
Boot Host Protocol section, disable TFTP order and Local order by
typing a
D
next to the corresponding field.
18.Enter
1
next to the
NFS order field.
19.Press
Enter
.
20.Press
PF5
(
Set Configuration Parameters).
21.Enter
peer.nsm
in the Configuration file field.
22.Enter
/QIBM/ProdData/NetworkStation/configs/
in the
Configuration
Directory: First
field.
23.Leave the
Configuration Directory: Second field blank.
24.Select
RFS/400
by using the left or right arrow keys in the
Configuration
Host Protocol: First
field.
25.Leave the
Configuration Host Protocol: Second as Default.