Technical data

SimpleComTools, LLC COM1000 – AT Commands
SimpleComTools, LLC 21
*SENDTO8 50 character alphanumeric value; can be phone number or email address
*SMSGETTIME SMS GET MESSAGE TIMER Frequency on which to check for SMS Messages
*SMSMODEM
SMS Modem Type;0 = No SMS Service Used1 = AirLink Redwing CDMA2 =
AirLink Redwing GPRS3 = AnyData iPort4 = Nokia GSM5 = Siemens M206 =
Wavecom Fastrack
*SMTPAUTH SMTP Server Uses Authentication;
*SMTPEMAIL EMAIL for SMTP Authentication:
*SMTPIP IP or Domain of SMTP Server. x.x.x.x or abc.123.com (Up to 50 characters)
*SMTPPASS SMTP Account Password;
*SMTPPORT
SMTP Server Port = nnnnnn
(5 digit value with range between 1 and 65535) (Default is 25)
*SMTPUSER SMTP Account Username;
*STATICIP
x.x.x.x = Static IP address to be assigned to the Ethernet interface. This is the
address to be used every time the device is powered up. Only takes effect if the
value *DHCP=0.Consult your Network Administrator for the appropriate IP
Address.
*STATUS
Configures interface values to be displayed by the 'STATUS' command.
This includes Analog Input, Digital Inputs, Relay State, and Modem status.
Multiple values are separated by commas. (Example AT*STATUS=1,2,3,4,5,6,7,8,9)
*TAPP1 Terminal Port Application #1;
*TAPP2 Terminal Port Application #2;
*TAPP3 Terminal Port Application #3;
*TBUFFER
Terminal Port Application Buffer Size: (n = 0- 256 KBytes). Amount of data to be
stored before executing any of the *TAPP selections. This value requires that
one of the TERMINAL PORT APP triggers be set to 4 (Buffer).Note: The buffer
size is shared between the TERMINAL and RS485 PORTS for a total of 256
KBytes. The amount available to one port will depend on the usage of the other.