Technical data

SimpleComTools, LLC COM1000 – AT Commands
SimpleComTools, LLC 10
*485TRIG3 RS485 Application #3 Trigger;
*485UDPDESTIP
IP or Domain of UDP Packet Destination. x.x.x.x or abc.123.com (Up to 50
characters)
*485UDPDESTPORT
UDP Packet Destination Port = nnnnnn
(5 digit value with range between 1 and 65535)
*485UDPSERVER UDP/Device Server Application
*AALARMREPT
Desired message recipient(s) as detailed in Messaging Config registers. =[n, n, n, n …
](Comma separation for multiple, ie 1,2,3,4,5,6,7,8) Max number = 8.
*ACALIBRATE
Calibrates the COM1000 to match the actual current sensor reading. If you know the
ACTUAL value being measured, you would enter that real value. The COM1000 will take
its current reading, and perform a calculation to come up with the offset so as to give you
a more accurate reading going forward.
*ACTMSGFREQ
Repeat Active Event Message Transmission Frequency; Frequency of
Repeating Active Event Messages. This value controls the behavior when a
Digital Input state or Analog Input value has not changed, and a repeat message
is about to be sent. Default is every 30 Minutes
*AHIGHALARM Displays High Alarm Count.
*AHIGHALARMACT Sets the High Alarm Action.
*AHIGHALARMMSG
Customized High Alarm Set Point Message. (Up to 20 characters) A free-text
field used in all UDP, TCP, SMS, and SMTP messages. For SMS and SMTP,
this will be seen as the SUBJECT field.
*AHIGHALARMSET High Alarm Set Point Set Point for exception reporting (n = 0.0-30.0)
*AHIGHWARN Displays High Warning Count.
*AHIGHWARNACT Sets the High Warning Action.
*AHIGHWARNMSG
Customized High Warning Set Point Message. (Up to 20 characters) A free-text
field used in all UDP, TCP, SMS, and SMTP messages. For SMS and SMTP,
this will be seen as the SUBJECT field.
*AHIGHWARNSET High Warning Set Point. The Set Point for exception reporting (n = 0.0-30.0)