Installation manual

SimpleComTools, LLC App Note: COM1000 – Wiegand Card Readers
7/27/2006 Simple Com Tools, LLC Page 7 of 9
Configuring the Card Access List
You will now configure the COM1000 with the list of authorized card IDs.
Step 1
:
Connect to the COM100 TERMINAL port using a terminal program, such as HyperTerminal.
Step 2
:
Obtain the COM1000 command prompt using the ENTER command.
COM1000 (c) 2003 SimpleComTools
Feb 04 2006 C1000.2005.29.W001
>
Step 3
:
Type AT*CARDSWIPE. This will bring up the WIEGAND card entry interface.
>AT*CARDSWIPE
CARDID01=0
CARDID02=0
CARDID03=0
CARDID04=0
CARDID05=0
CARDID06=0
CARDID07=0
CARDID08=0
CARDID09=0
CARDID10=0
SWIPE CARD OR TYPE Q TO EXIT >
Step 4
:
Swipe the first card you wish to enter. The card ID will appear on the screen.
You will be asked to accept the card ID position or enter a position number.
Make your selection and hit ENTER.
CARD ID = 35724
ENTER ID POSITION 1 - 30, 0 to cancel, Q to quit > 1
CARDID01=35724
CARDID02=0
CARDID03=0
CARDID04=0
CARDID05=0
CARDID06=0
CARDID07=0
CARDID08=0
CARDID09=0
CARDID10=0
SWIPE CARD OR TYPE Q TO EXIT >
Step 5
:
After entering all the cards, enter ‘Q’ to quit the card ID entry application.
SWIPE CARD OR TYPE Q TO EXIT > Q
TYPE AT&W TO SAVE CHANGES
>
Step 6
:
Save the settings and reset the device.
>AT&W
Changes will take effect after reboot
>ATZ