Installation manual

SimpleComTools, LLC App Note: COM1000 – Wiegand Card Readers
7/27/2006 Simple Com Tools, LLC Page 5 of 9
Step 4
:
Set the APPLICATIONS and TRIGGERS for cards that are swiped.
Applications will run only when the trigger criteria is met. Therefore you will need to set an application and the
corresponding trigger before anything will happen. For example, WAPP1 needs to have WTRIG1 be a non-zero
number in order for the application to run. Your choices are as follows:
Application 1
AT*WAPP1=n
Sets the first of 3 applications to run on the Terminal Port. Enter the value representing
how you want the Terminal Port to handle incoming serial data.
Options:
0 = No Action
1 = Card Data - UDP
(Sends card data to remote IP via UDP packet)
2 = Card Data - TCP
(Sends card data to remote IP via TCP packet)
3 = Card Data - SMTP
(Sends card data to remote user via SMTP message)
4 = Card Data – SMS (Future application)
(Sends card data to remote user via SMS message)
5 = Card Data – FTP (Future application)
(Uploads card data to remote server via FTP)
6 = Card Data - Relay ON
(Open/energize relay based on Card ID)
7 = Card Data - Relay OFF
(Close/de-energize relay based on Card ID)
Application 2
AT*WAPP2=n
Sets the 2nd of 3 WIEGAND applications.
Options: Same as Application 1
Application 3
AT*WAPP3=n
Sets the 3rd of 3 WIEGAND applications.
Options: Same as Application 1
Trigger 1
AT*WTRIG1=n
Sets the trigger that will initiate the Application #1 event.
Enter the value representing how you want the application to start.
Options:
0 = None
1 = All Cards
(App will send card ID whether it is a match or not)
2 = Matched Cards
(App will send card IDs that match those in the lookup table)
3 = Unmatched cards
(App will send card IDs that fail to match those in the lookup table)
Trigger 2
AT*WTRIG2=n
Sets the trigger that will initiate the Application #2 event.
Enter the value representing how you want the application to start.
Options: Same as Trigger 1
Trigger 3
AT*WTRIG3=n
Sets the trigger that will initiate the Application #3 event.
Enter the value representing how you want the application to start.
Options: Same as Trigger 1