Installation manual

SimpleComTools, LLC App Note: COM1000 – Wiegand Card Readers

7/27/2006 Simple Com Tools, LLC Page 4 of 9

Wiring Diagram

Configuring the COM1000 to Communicate with the Card Reader

After installation of the reader, connect the COM1000 to a computer to the TERMINAL port using the RS232 serial

cable. You will now configure the COM1000 to interface with the card reader and develop the access list.

Step 1

Connect to the COM100 TERMINAL port using a terminal program, such as HyperTerminal.

The default baud rate is 115200, 8N1. HW flow control is not necessary.

Step 2

Obtain the COM1000 command prompt using the ENTER command.

May 04 2006 C1000.2005.29.W128

Step 3

Type AT&V=5.

This will provide the COM1000/Wiegand card reader settings.

*WAPP1:0

*WAPP2:0

*WAPP3:0

*WTRIG1:0

*WTRIG2:0

*WTRIG3:0

*WBUFFER:0

*WREPORT: 0

*WUDPDESTIP:0.0.0.0

*WUDPDESTPORT:0

*WTCPDESTIP:0.0.0.0

*WTCPDESTPORT:0

*WEVENTMSG:

*WRECIPIENT:0

*CARDID01:0

*CARDID02:0

*CARDID03:0

Etc…

Optional

Unused

Black

Shield

Red

Orange

Green

White

Yellow

Brown

Blue

Violet