Use and Care Manual

Rev: 16-04-01

PAGE 1
Rev: 16-04-01
PAGE 2
PAGE 3
Screw #D Allen wrench
PAGE 4
1. Place the backrest w/legs (#1) onto a protected surface. 3. Insert 2 bolts (#A) into each end of the seat frame (#3) and secure using the Allen wrench. 2. Align both ends of the seat frame (#3) to the pre-drilled holes along the front of the backrest w/legs (#1). 6 2. Insert 3 bolts (#A) into each leg (#4) and secure using the Allen wrench. 1. Align the legs (#4) to the front of the seat frame (#3).
PAGE 5
2. Insert a bolt (#A) into the hole connecting to the seat frame (#3) and secure using the Allen wrench. 1. Align the right stretcher support (#5R) to the right #5L side of the backrest (#1) and seat frame (#3). 3. Insert a bolt (#B) into the hole connecting to the seat backrest with legs (#1) and secure using the Allen wrench. #5R 4. Repeat the process for the left stretcher support (#5L). 1. Place the seat (#2) onto the seat frame (#3). 2. Insert 4 screws (#C) from below and secure.