Installation Guide
12
• First, put some silicon or liquid soap on the toilet spigot
• Fit the collar supplied on the bowl outlet
• Pull the flexible sleeve over the pan spigot
• Position the jubilee clip over the edge of the flexible sleeve, and tighten with a screwdriver
•Once the appliance has been positioned, fix it to the floor using the 2 screws supplied.
If using the two floor fixing lugs, secure them to the floor before positioning the unit.
WARNING !!!
There should be no dripping of water from the toilet cistern or any other sanitary appliances. If
there is, this will cause the unit to activate repeatedly as it pumps the water away.
3b
CONNECTION OF DISCHARGE PIPEWORK
Insert the discharge elbow into the rubber discharge pipe, turn to the desired direction and secure
with the metal jubilee clip provided (36-50mm). Then connect the hose to it using
the 20-32mm metal jubilee clip, making sure the hose is not kinked. A 22-32mm plastic reducer is
supplied if 32mm discharge pipework is to be installed.
3c TECHNICAL ADVICE FOR DISCHARGE PIPEWORK
•Horizontal pipe runs must have a minimum fall of 1:200 (5mm per metre) to the soil stack,
•If a vertical lift is required, it must be made before the horizontal run at the start of the piperun,
• We would recommend that a drain-off point is installed to allow the discharge pipework to be drained
down before any service work
• If the discharge pipework runs to a level considerably lower than the unit, the resultant syphoning
effect can suck out the water seal in the unit. Fitting an air admittance valve (BBA approved) at
the high point of the pipe run will overcome this problem,
•The discharge pipework must be connected • to the soil stack using an appropriate strap on boss,
Ensure all external pipework is adequately lagged to avoid the possibility of freezing.
N.B.
: Any elbow on the discharge pipe of the unit will create friction loss (roughly 50 cm per elbow
to be deducted from the vertical pumping spec.)
Always use smooth bends (OR 2 X 45 degree bends together) and not 90 degree elbows.
.