Operation Manual

THE NEXT GENERATION CAR SEAT / DOONA BASE

WARNING!

• DO NOT use the blue lock-offs to lock the vehicle seat belt

straps when installing the Doona Base with a lap belt.

•

Vehicle seat belt must lock, otherwise use a locking clip.

Ensure proper installation of the Doona Base:

• Ensure that the seat belt strap is tight and the base is secured. The

base is secured when it moves less than 1 inch (2.5 cm) side to side or

back to front.

• The base is leveled when the white

markers on the recline level indicators

(#9) on both sides are completely within

the green area.

• Uninstalling the base when installed with a LATCH connection –

release the LATCH connectors (#8) from the LATCH anchor points in

the vehicle (pic.1). Press and hold the red LATCH connector release

buttons (#7) and pull them off (pic.2). Store the LATCH connectors by

pushing them into their storage slots in the base until they click into

place (pic.3).

• Uninstalling the base when installed with a Lap-Shoulder or Lap belt

connection - open the belt lock-offs (#4) (in case of lap-shoulder

connection only) to release the vehicle belt (pic.4), then unbuckle

the vehicle belt (pic.5) and pull it through and out of the vehicle belt

guides (pic.6).

7.6. Uninstalling the Base