Operation Manual

THE NEXT GENERATION CAR SEAT / DOONA BASE

WARNING!

• DO NOT lock both of the blue lock-offs onto the vehicle

seat belt!

• Vehicle seat belt must lock otherwise use a locking clip.

Step 1: Place the Doona Base in the desired location on the vehicle

seat.

Step 2: Pull the vehicle’s Lap-Shoulder belt. Ensure it is not twisted.

Step 3: Route the vehicle seat belt under and through the rst vehicle

belt guide (#3), then through the second vehicle belt guide (#3) (pic.a).

Step 4: Engage the vehicle seat belt buckle tongue in the vehicle seat

buckle (pic.b).

Step 5: Tighten the lap belt section by pulling up the shoulder section of

the vehicle seat belt (pic.c). Engage the locking mechanism and then

feed the belt back into the retractor.

Step 6: Once the vehicle seat belt has been tightened, lock the

blue lock-off clip to prevent the shoulder sliding (pic.d). Make sure

to only use the lock-off placed opposite from the side where the

vehicle belt is engaged into the vehicle seat buckle.

Note: The blue lock-off will not make a click sound when locked.