Operation Manual

Step 1: Release the LATCH connectors (#8) from their storage slots in

the Doona Base - press and hold the red LATCH connector release

buttons (#7) and pull the LATCH connectors out (pic.a).

Step 2: Lengthen the LATCH adjuster strap (#5) - press and hold the

LATCH adjuster strap release button (#6), then pull the strap (pic.b).

Step 3: Place the Doona Base in the desired location on the vehicle seat.

Insert the base’s LATCH connectors into the vehicle’s LATCH anchor

points, then press them until you hear a click sound (pic.c).

Step 4: Tighten the LATCH adjuster strap (#5) - while pressing the Doona Base

down into the seat and pulling the LATCH adjuster straps up (pic.d).

INSTALLING THE DOONA BASE