Operation Manual
THE NEXT GENERATION CAR SEAT / DOONA BASE
26
WARNING!
DO NOT use the blue lock-offs to lock the vehicle seat belt
straps when installing the Doona Base with a lap belt.
Ensure proper installation of the Doona Base:
• Ensure that the seat belt strap is tight and the base is secured. The
base is secured when it moves less than 1 inch (2.5 cm) side to side or
back to front.
• The base is leveled when the white
markers on the recline level indicators
(#9) on both sides are completely within
the green area.
Uninstalling the base when installed with a LATCH connection:
Step 1: release the LATCH connectors (#8) from the LATCH anchor
points in the vehicle (a).
Step 2: Press and hold the red LATCH connector release buttons (#7)
and pull them off (b).
Step 3: Store the LATCH connectors by pushing them into their storage
slots in the base until they click into place (c).
Uninstalling the base when installed with a Lap-Shoulder or Lap belt
connection:
Step 1: open the belt lock-offs (#4) (in case of lap-shoulder connection
only) to release the vehicle belt (d).
Step 2 Unbuckle the vehicle belt (e) and pull it through and out of the
vehicle belt guides (f).
7.6. Uninstalling the Base