Operation Manual

THE NEXT GENERATION CAR SEAT / DOONA BASE
24
7.5. Lap Belt Installation
•
Before installing the Doona Base in the vehicle, ensure
that the vehicle seat belts are compatible (see chapter
6.3.).
•
For lap belt installation, check your vehicle manual for
information on how to lock your vehicle seat belt system.
•
The Doona Base must be secured in the vehicle before
installing the Doona Infant Car Seat on it.
•
Before using the Doona Base in the vehicle, you must rst
adjust its level. The base’s level can be adjusted only as
described in this user guide.
•
Ensure that the base is not raised from the front edge of
the vehicle seat. In the event of an accident it might
disrupt the correct functioning of the base.
•
The Doona Base can be installed in the vehicle either
with the LATCH system or with the vehicle’s belt. DO NOT
attempt to install the Doona Base using both the LATCH
system and the vehicle’s belt, it is not approved and
might disrupt the correct functioning of the Doona Infant
Car Seat and the Doona Base.
•
When installing the Doona Base with a lap belt, ensure
LATCH connectors are always stored in their storage slots
in the base.
WARNING