Operation Manual

THE NEXT GENERATION CAR SEAT / DOONA BASE

WARNING!

DO NOT lock both of the blue lock-offs onto the vehicle

seat belt!

Step 1: Place the Doona Base in the desired location on the vehicle

seat.

Step 2: Pull the vehicle’s Lap-Shoulder belt. Ensure it is not twisted.

Step 3: Route the vehicle seat belt under and through the rst vehicle

belt guide (#3), then through the second vehicle belt guide (#3) (a).

Step 4: Engage the vehicle seat belt buckle tongue in the vehicle seat

buckle (b).

Step 5: Tighten the lap belt section by pulling up the shoulder section of

the vehicle seat belt (c).

Step 6: Once the vehicle seat belt has been tightened, lock the

blue lock-off clip to prevent the shoulder sliding (d). Make sure

to only use the lock-off placed opposite from the side where the

vehicle belt is engaged into the vehicle seat buckle.

Note: The blue lock-off will not make a click sound when locked.