Operation Manual

21
7.4. Lap-Shoulder Belt Installation
•
Before installing the Doona Base in the vehicle, ensure
that the vehicle seat belts are compatible.
•
The Doona Base must be secured in the vehicle before
installing the Doona Infant Car Seat in it.
•
Before using the Doona Base in the vehicle, you must rst
adjust its level. The base’s level can be adjusted only as
described in this user guide.
•
Ensure that the base is not raised from the front edge of
the vehicle seat. In the event of an accident it might
disrupt the correct functioning of the base.
•
The Doona Base can be installed in the vehicle either
with the LATCH system or with the vehicle’s belt. DO NOT
attempt to install the Doona Base using both the LATCH
system and the vehicle’s belt, as it is not approved, and
it might disrupt the correct functioning of the Doona
Infant Car Seat and the Doona Base.
•
When installing the Doona Base with a lap-Shoulder
belt, ensure LATCH connectors are always stored in their
storage slots in the base.
WARNING
INSTALLING THE DOONA BASE