Operation Manual
17
INSTALLING THE DOONA BASE
7.2. LATCH Connectors
To release the LATCH connector (#8)
from its storage slot in the Doona
Base or from the LATCH anchor
points in the vehicle, press and hold
the red LATCH connector release
button (#7) and pull it out.
To store the LATCH connectors (#8),
push them into the storage slots in
the base until they click into place.
The Doona Base can be installed in the vehicle either with the LATCH
system or with the vehicle’s belt.
LATCH stands for Lower Anchors and Tethers for Children; these
anchors are specically designed for car seats installation.
Since 2002, LATCH connectors are required by law in the USA for all
vehicles.
Check your vehicle manual to ensure that the vehicle is equipped with
LATCH anchor points.
WARNING!
LATCH connectors should always be stored in their storage
slots in the base when not in use.