Full Product Manual

S-TRAP WITH DISPOSAL
This page is for waste lines located behind or past your disposal.
FORMING THE S-TRAP
Hang the uncut tube from the TEE and form an “S”
shape while holding the other end next to the waste
to measure the length. Use the loop and depth tab to
help make sure the trap portion of the “S” is correct.
Helpful tips:
• Try to keep the bottom of the trap above the top of
the waste if possible.
• Leave extra length when you cut because you may
want make adjustments once installed.
• Remove tube from TEE before you cut to length.
• S-traps are never to code, but it is still important to
form a proper trap using the loop and depth guide
as shown.
Once satised with the trap shape, measure, cut, and
attach the threaded tting to the tube.
Thread tube to the waste. Attach tube to bottom of
TEE with hand-tighten clamp and ensure all other
connections are tight. Check for leaks and adjust as
needed. Apply disinfecting clip to trap loop for future
use. Optional rubber band or zip tie may help keep
upper bend in place.
Set one tube aside until you nish STEP 4.
Trim tube 4 ribs in from the cu.
Clamp to disposal outlet:
• ELBOW outlet: Push cu onto top of TEE (with
dishwasher stub pointing toward disposal) and
clamp. Apply a second clamp into the rst valley
on the raw end of the tube. Push ribs over the
elbow until it hits the TEE and tighten.
• STRAIGHT outlet: With dishwasher stub upward,
push cu onto side of TEE facing disposal and
clamp. Apply a second clamp into the rst valley
on the raw end of the tube. Push ribs over dis
-
posal outlet until it hits the TEE and tighten.
Attach to sink:
• Using remaining piece of tube from STEP 2,
push cu onto TEE facing the sink drain and
measure. Remove tube from TEE and cut to
length.
• Attach threaded tting.
• Thread onto sink drain.
• Setup should look like either gure
2B
D
2C
S-trap with disposal installation (waste BEHIND disposal)
Read the basic concepts section on the back cover, then follow the instructions below to install your
double basin Simple Drain. The green and blue bubble will guide your success.
1
2
3
4
7
6
5
A
2C 4B
or
B
C
Inside curve of tube
follows depth tab
shape
Optional rubber
band or zip tie
FORMING THE TRAP
4B
2B
3B
1. Clamp 4 rib section to straight
outlet and TEE.
2. Measure, trim, attach, and
clamp per step 4.
PAGE 6
S-TRAP WITH WASTE
BEHIND DISPOSAL
WASTE BEHIND
DISPOSAL
Confused? Don’t be.
Watch our how-to videos!
WASTE BEHIND DISPOSALWASTE BEHIND DISPOSAL
6
6
7
7
7
1B
1B
2C
3B 2C
or