Full Product Manual

S-TRAP WITH DISPOSAL
This page is for waste lines located opposite the disposal.
Set one tube aside until you nish STEP 8.
Point dishwasher stub on TEE away from disposal
and align top of TEE side port to bottom of disposal
outlet as shown by dashed blue line.
Push tube onto the TEE and hold in position below
the drain. Mark the rib where it meets the sink drain.
Add an extra rib or two in case you need to re-cut
and trim tube.
Attach threaded tting.
Thread onto sink drain and then attach TEE with
clamp. It should look something like the inset box
Using remaining portion of the rst tube, push cu
onto the side of the TEE facing the disposal and
measure over to the disposal outlet so that 4 ribs
go over the outlet. If outlet is straight, run tube
directly across and ensure tube slopes down to TEE.
Remove tube from TEE and then cut to length.
Clamp cued end to TEE. For cut end, put clamp
into rst valley, push 4 ribs onto disposal outlet, and
clamp tightly.
B
3A
A
3A
C D
4A
5A
S-trap with disposal installation (waste OPPOSITE disposal)
Read the basic concepts section on the back cover, then follow the instructions below to install your
double basin Simple Drain. The green and blue bubble will guide your success.
1
2
3
4
5
6
7
2A
FORMING THE S-TRAP
Hang the uncut tube from the TEE and form an “S”
shape while holding the other end next to the waste
to measure the length. Use the loop and depth tab to
help make sure the trap portion of the “S” is correct.
Helpful tips:
• Try to keep the bottom of the trap above the top of
the waste if possible.
• Leave extra length when you cut because you may
want make adjustments once installed.
• Remove tube from TEE before you cut to length.
• S-traps are never to code, but it is still important to
form a proper trap using the loop and depth guide
as shown.
Once satised with the trap shape, measure, cut, and
attach the threaded tting to the tube.
Thread tube to the waste. Attach tube to bottom of
TEE with hand-tighten clamp and ensure all other
connections are tight. Check for leaks and adjust as
needed. Apply disinfecting clip to trap loop for future
use. Optional rubber band or zip tie may help keep
upper bend in place.
10
9
8
Straight outlet
Cut here
Cut here
Disposal
outlet
Cut here
Try to keep base of
trap above the waste
6
FORMING THE TRAP
PAGE 5
S-TRAP WITH WASTE
OPPOSITE DISPOSAL
WASTE OPPOSITE
DISPOSAL
Confused? Don’t be.
Watch our how-to videos!
WASTE OPPOSITE DISPOSALWASTE OPPOSITE DISPOSAL
Completed
6
6
7
7
5A
4A3A
1A
1A
2A