Full Product Manual
Waste left,
dishwasher stub left
Waste center,
dishwasher stub up
Waste right,
dishwasher stub right
Set aside one of the white rubber tubes and do not cut until STEP 8.
Locate your waste pipe. The TEE will go under the sink drain closest
to the waste. If generally centered, the TEE will be as well.
Trim hose to length.
• For left/right install, count 8 ribs from either end and trim. If you
need to re-cut, 6 or 7 ribs will still work.
• For a center install, count 20 ribs and trim.
Attach threaded tting.
Thread onto sink drain, then push TEE into the cu and attach with
clamp. See 2A for left/right install or 2B for center.
Using the tube you already cut, push the cu end over the TEE and
measure over to the other side of the sink and note which rib meets
the drain.
Remove tube from TEE, trim to length, attach threaded tting,
thread onto sink, and clamp to TEE. (See “Assembled” inset image)
FORMING THE S-TRAP
Hang the uncut tube from the TEE and form an “S” shape while
holding the other end next to the waste to measure the length. Use
the loop and depth tab to help make sure the trap portion of the “S”
is correct. Helpful tips:
• Try to keep the bottom of the trap above the top of the waste if
possible.
• Leave extra length when you cut because you may want make
adjustments once installed.
• Remove tube from TEE before you cut to length.
• S-traps are never to code, but it is still important to form a prop-
er trap using the loop and depth guide as shown.
Once satised with the trap shape, measure, cut, and attach the
threaded tting to the tube.
Thread tube to the waste. Attach tube to bottom of TEE with
hand-tighten clamp and ensure all other connections are tight.
Check for leaks and adjust as needed. Apply disinfecting clip to trap
loop for future use. Optional rubber band or zip tie may help keep
upper bend in place.
Center waste
Standard S-trap Installation
Read the basic concepts on the back cover, then follow the instructions below to
install your Simple Drain. The green and blue bubbles will guide your success.
Waste left,
dishwasher stub left
Waste center, dishwasher stub up
Inside curve of tube follows
depth tab shape
Optional rubber
band or zip tie
Cut here
Left/right waste
1
5
A
B
2A 2B
C D
4A 4B
1
7
8
9
10
2
3
4
5
6
Assembled Assembled
3A 3B
or
S-TRAP
Confused? Don’t be.
Watch our how-to videos!
PAGE 2
S-TRAP
4B
54A
3A
1
2A
3B
2B