User guide

28 Part # 11313539 Rev. B
Loading BeadChips
3 Lowerthecarriergentlyontothetray(BeadChipbarco deendsnearfrontoftray)and
lightlyjiggleitfromsidetosidetoensurethatitfitssecurely.Donotpressdownon
theiScanReadertray.
Figure20PlacingtheBeadChips
Youmaynoticesomeback‐and‐forthplayinthecarrierafterplacingitintotheiScan
Readertray;thisisacceptable.TheiScanReaderwillautomaticallycenterand
positiontheBeadChipsforproperscanning.
4 ToclosetheiScanReadertray,dooneofthefollowing:
• ClicktheMenubutton intheupperleftcorneroftheICSscreenandselect
Scanner|CloseTray.
• PresstheOpen/CloseTraybuttononthefrontoftheiScanReader.
5 ClickNext.
Themessage“ScanningBarcodesPleasewait...”appearsonscreenwhileaninternal
devicescanstheBeadChipbarcodes.
Whenbarcodescanningiscomplete,theICSSetupscreenappears.TheBeadChips
areshownonscreeninthelocationscorrespondingtotheirpositionsinthecarrier.
Ifthebarcodescannerfindsanemptyslotbarcode,theiScanControlSoftware
identifiesthatslotwiththewordEMPTY.OtherBeadChipsloadedinthecarrierwill
processnormally.